We are offering excellence in the form of Exposed Steel Anticorrosive, Polyurethane Coating to enhance the buyers' content. We are backed by a well structured and capacious storehouse that assists us in furnishing urgent and quick requirements of the clients. Moreover, we ensure complete safety of the stored items.
| Product Code : LP370 | Brand Name : UGAM |
1) Ugam Anticorrosive PU Product Is Used In Outdoor Areas Of Exposed Steel.
2) UGAM P U TOPCOAT is used for prevention of corrosion in coastal areas.
3) It is used over UGAM ANTICORROSIVE EPOXY PRIMER FOR COASTAL AREAS.
4) This provides duel system of anticorrosion in coastal areas.
5) This is proven system for prevention of corrosion.
6) Since P U is having very high weathering resistance, it is used in topcoat.
7) Special ingredients make it anticorrosive and protect steel surface.
8) Ugam Anti corrosive PU Provides Very Good Weather Resistance For Protection Of Steel.
9) Ugam Anti corrosive PU Coating Is Far Superior To Epoxy Coatings As This Is Having Very Good Weather Resistance.
10) Once Used This Does Not Need Re Application For About Ten Years.
11) Ugam Anti corrosive PU Also Is Useful over Concrete Surfaces near Water like Bridges or in Heavy Rainfall Areas. Bridges, Flyovers Are Coated With Ugam Anti corrosive PU.
12) Multi-storey Buildings Are Also Coated With Ugam Anti corrosive PU.
13) This Coating Provides Very Nice Aesthetic Look Too!
14) Ugam Anti corrosive PU Is Most Suitable Coating for Protection As Well As Aesthetic Value.
Application Procedure of UGAM ANTICORROSIVE EPOXY / PU COATING:
1) UGAM ANTICORROSIVE EP /PU system is easy to use.
2) First prepare the surface with shot blasting in case of steel, high pressure water spray with minimum 300 bar pressure for concrete. In case high pressure machine is not available, wash with soap water and wire brush scrapping.
3) Apply UGAM EPOXY PRIMER with brush, spray or roller. It is two pack system which need mixing of base with hardener in given ratio.
4) After mixing of base and hardener, UGAM THINNER FOR EPOXY needs to be added to achieve required viscosity as per application procedure.
5) Allow it to cure overnight.
6) Apply UGAM ANTICORROSIVE PU first coat with brush, spray or roller as required.
Since this is also two pack system, it also requires mixing of base with hardener in Given ratio before application.
7) After mixing of base and hardener, UGAM THINNER FOR EPOXY / PU need to be added to achieve required viscosity as per application procedure.
8) Allow it to cure overnight.
9) Then apply second coat of UGAM ANTICORROSIVE PU by again mixing base+hardener+thinner as above.
10) The surface will be ready to use after 48 hours of final coating.
You can Email us on sales.ugamchem@gmail.com or contact us on +91-7219872619.
The technical specification is correct to the best of our knowledge and under test conditions and we do not accept any liability
towards misuse and contents of it. Product must be tested for specific use prior to use.
